beautypg.com

Dirt sensor, Caution, Belt changing and agitator cleaning – Kenmore 116.25812 User Manual

Page 18: To remove belt, Belt changing and agitator cleaning to remove belt

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

DIRT SENSOR

Although the dirt sensor feature In your

Kenmore Power-Mate® Is designed for years of
trouble free use, the passage of dirt through

the air passage system can coat the lens
causing the green light to come on and stay
on - never sv/Itching to red. When this happens
the lenses must be cleaned.

CAUTION

Never use water or any cleaning solution

when cleaning the lenses. The residue of
the water or cleaners will accelerate the
recoating of the lenses and make
cleaning necessary sooner.

TO CLEAN THE LENSES

1

.

Remove the

wand by pressing
the quick release
pedal and lifting
up on the wand.

2. As indicated by the illustration, the two dirt
sensor elements are located on the inside of
the swivel, approximately 3% inches/90 mm
down, (note the arrows) Each element should
be cleaned periodically. To reach the sensor
elements* use a small brush such as a bottle
brush. Brush each sensor element several

times to remove dust and dirt,

NOTE:

Looking down inside the swivel you will

see a ring. The sensor elements are iocated

just slightly below this ring.

3. Reinstall the wand after cleaning the sen­
sors.

BELT CHANGING AND AGITATOR CLEANING

TO REMOVE BELT

3

.

Turn Power­

Mate® right side
up. Press handle
release pedal and
lower the swivel,
Lift rear latches
up.

1. Turn Power­
Mate®

down.

upside

2. Unscrew the
two {2} Power­
Mate® cover
screws.

Side

Latch

Rear

Latches

5. Lift agitator
assembly out
and remove
worn belt.

4

,

To remove cover,

grasp the sides and
pull out

£ftd Cap

6. Check and clean end cap areas. See

agitator

assembly

for picture of

complete agitator assembly

18