beautypg.com

Warning – Kenmore 116.22822 User Manual

Page 20

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Review this chart to find do-it-yourself solutions for minor performance problems. Any service
needed, other than those described in this owner’s manual, should be performed by a Sears
Service Center.

A

t

WARNING

Electrical Shock Hazard

Disconnect electrical supply before servicing or cleaning the unit.
Failure to do so could result in electrical shock or personal injury.

Cleaner won’t start

1. Unplugged at wall outlet.

2. Tripped circuit breakerTblown fuse

at household service panel.

3. Loose hose electrical connections.
4. Tripped thermal protector in

canister.

1. plug in firmly, push ON/OFF switch to

ON.

2. Reset circuit breaker or retrace fuse.

3. RetMnnect hose ends, (page 7).
4. Reset thermal protector, (page 12).

Poor Job of dirt
pick-up.

1. Full or clogged dust bin.

2. Clogged airflow passages.
3. Dirty raters.
4. Wrong pile height setting.
5. Open suction control.
3. Hole in hose.
7. Worn Power-Mate® brushes.

B. Worn or broken belt.
9. Dirty agitator or end caps.

1. Empty dust din, (page 14).
2. Clear airflow passages, (page 13).
3. Clean/change filters, (page IS, 16).

4. Adjust setting, (page 10].

5. Adjust control, (page 9).

6

. Replace hose.

7. Change brushes, (page 20).

8

& 9. See BELT CHANGING AND AGITATOR

CLEANING, (pages 17-18),

Cleaner starts but

cuts off.

1. Hose electrical connections.

2. Tripped overload protector in

Power-Mate®.

3. Tripped thermal protector

in canister.

1. Check connections, reconnect hose

ends, (page 7).

2. Remove any items that may be caught

or jammed, then reset (page

12

). if

cleaner starts and stops again, clean
agitator and end caps, then reset
(pages 17-18).

3. Reset thermal protector, (page 12).

Power-Mate* wttl not
run when attached.

1. Power-Mate* connecfions

unplugged.

2. Worn or brdren belt

3. [k'rty agitator or end caps.
4. Tripped overload protector in

Power-Male®

1. Plug in firmly, (page

6

).

2 & 3. See BELT CHANGING /WD AGITATOR

CLEANING, (pages 17-18).

4

.

Check agitator area for excessive lint

build-up or jamming (page

12

). and

Clean agitator, end caps, then reset,
(pages 17-18).

Cleaner picks up moveable
ni

0

s -or- Power-Male*

pushes too hard.

1. Wrong pile h^ghl setting.

2. Suction too strong.

1. Adjust setting, (page

8

).

2. Adjust suction control, (page 9).

tight won't wotk.

1. Bianed out light bulb.

1. Change Sght bulb, (page 19).

Cord won't rewind.

1. Dirty power cord.
2. Cord jammed.

1. Clean the power cord.
2. Pull out cord and rewind.

Cleaner leaves marks
on carpet

1. Wrong vacuumktg pattern.

1. See VACUUMING TIPS, (page 10).

20

This manual is related to the following products: