Warning, Auto-cleaning system, Edge cleaner – Kenmore 116.22822 User Manual
Page 12: Overload protector, Power-mate, Storage, Thermal protector
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EDGE CLEANER
Active brush edge
cleaners are on both
sides of the Power
Mate*. Guide either
side of the Power
Mate* along base
boards or next to
furniture to help
remove dirt trapped at
carpet edges.
OVERLOAD PROTECTOR
Overload Protector
Reset Button
The Power
Mate* has built-
in protection
against motor
and belt
damage should
the brush jam. If
the bmsh slows
down or stops,
the overload
protector button
pops up and shuts off the Power-Mate*^. The
canister motor will continue to run.
To correct problem: Remove any items that
may be caught or jammed, then reset {See
Troubleshooting).
To reset: Push in the oveiload protector
button.
A
WARNING
Personal Injury Hazard
Always unplug the vacuum cleaner
before cleaning the brush area as
brush may suddenly restart. Failure
to do so can result in personal
injury.
AUTO-CLEANING SYSTEM
This vacuum cleaner is equipped with a auto
cleaning system. Each time the power cord is
extended a cleaning cam located inside the
dust bin rotates and cleans the filter.
POWER-MATE«
SOME MODELS
STORAGE
The lower virand has a
'LT shaped flange in
the area where the
power cord attaches.
The canister has a ‘‘U’’
shaped slot near the
rear of the canister.
The slot allows the
wands and Power
Mate* to be stored
with the canister to conserve storage space.
The wand will slide into the slot as it is low
ered for storage and will slip out of the slot
as it is lifted up for use.
THERMAL PROTECTOR
This vacuum has a thermal protector which
automatically trips to protect the vacuum
from overheating. The thermal protector
turns the motor off automatically to allow the
motor to cool in order to prevent possible
damage to the vacuum.
To reset: Turn off and unplug the vacuum
from ttie outlet to allow the vacuum to cool.
Check for and remove any dogs. Also
check and replace any clogged filters.
Wait approximately 30 minutes and plug
the vacuum in and turn back on to see if
the thermal protector has reset. In some
cases, the unit may suddenly restart. DO
NOT leave plugged in unattended.
12