Kenmore 116.22822 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO REMOVE BELT
1. Turn Power
Mate® upside
down.
2. Unscrew the
two (2) Power
Mate® cover
screws.
3. Turn Power
Mate® right side
up. Press handle
release pedal and
lower the swivel.
Lift rear latches up.
4. To remove cover,
grasp the sides and
pull out, then up.
5, Depress tabs
on rear of
agitator cover
and rotate cover
fonvard to
release from the
Power-Mate®
base and
remove.
Agitator
Cover
6. Lift agitator
assembly out
and remove
worn belt.
TO REPLACE BELT
1. install new
belt over motor
drive, then over
brush sprocket.
NOTE; See
PARTS AND
FEATURES
for the belt
number.
End Cap
Agitator
2. Place agitator
assembly back into
Power-Mate®.
3. Reinstall agitator cover
by lining up the front tabs
and slots and rotat
ing downward until
the latches
snap into ^
place.
Agitator Cover
Base
4. Line up
front of
cover and
base. Rest
cover on
front edge
of base as
shown.
5. Rotate cover
back. Press
cover firmly until
side and rear
tabs snap into
place. Turn
Power-Mate®
upside down and
replace two (2)
cover screws.
18