Kenmore 114.85925 - Manual (Page 9)

FILL
Remove Tank-in­
Tank™ System from
cleaner by pushing
down on tank latch
and tilting out.
Remove measure cap
from the rear of the
Clean Water Tank.
Pour 4 capfuls of
Kenmore® Hard Floor
Concentrate Cleaner
into Clean Water Tank.
DO NOT USE PINE,
SOLVENT, OR WAX
BASED CLEANING
SOLUTIONS IN
CLEANER.
Fill remainder of Clean
Water Tank with warm
water up to the MAX
FILL line. Replace
measure cap on Clean
Water Tank.
Replace Tank-in-Tank™
System by inserting
bottom first and tilting
forward until tank
latch fastens.
VACUUM
With dry hands, plug
cord into properly
grounded electrical
outlet.
Step on Nozzle
Setting pedal if
necessary to
switch from WET
SCRUB & VAC to
HARD FLOOR
DRY VAC.
Turn cleaner on by
moving power on/off
switch from OFF to
ON.
Step on Handle
Release pedal to put
into cleaning position.
Slide Brush On/Off
switch to the OFF
position if necessary.
Operate cleaner to dry
vacuum the entire
hard surface area.