Brushroll reset button, Thermal protector, After cleaning – Kenmore 114.85925 User Manual
Page 13: Emptying and cleaning the tank-in-tank" system, Warning, Empty tank-in-tank™ system, Emptying and cleaning the, Tank-ln-tank’" system -14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BRUSHROLL RESET
BUTTON
IMPORTANT:
Your cleaner contains a
reset button to protect the permanent belt
should the brushroll clog. If this occurs,
unplug the unit, remove debris from
brushroll, and push reset button prior to
resuming operation.
THERMAL PROTECTOR
IMPORTANT:
Your cleaner contains a
thermal protective device to shut off the
motor to avoid overheating. If this
happens, turn the unit off and unplug the
cleaner. Inspect the nozzle inlet for
blockage. Empty the Dirty Water Tank and
clean filter. After approximately 30
minutes, the motor will have cooled and
the vacuum will be ready to use.
NOTE:
The cleaner must remain unplugged
during the 30 minute cooling period.
AFTER CLEANING:
• Allow carpet to dry completely. Try not
to walk on the carpet until it is dry.
• If you need to walk on the carpet, place
white towels on the areas you want to
walk,
• If the carpet is not dry and furniture
must be placed back in the room, use
plastic or foil under the furniture to
prevent staining the carpet.
■ Thoroughly clean the dirty water
tank with warm tap water.
EMPTYING AND CLEANING THE TANK-IN-TANK" SYSTEM
A
WARNING
To reduce the risk of Injury from
moving parts unplug before
servicing.
Tank-in-Tank™ System:
The cleaner is
designed with a unique Tank-in-Tank™
system. The Clean Water Tank (outer
tank) contains the cleaning solution and
clean water mixture while the Dirty Water
Tank (inner tank) collects wet and dry
debris.
EMPTY TANK-IN-TANK™
SYSTEM
Turn cleaner off and
disconnect from
electrical outlet.
Remove Tank-in-Tank"
System by pushing
down on tank latch
and tilting out from
cleaner.
Grasp tab on
filter/float assembly
and pull up to remove
from tank. Empty con
tents of Dirty Water
Tank.
Rinse and dry the
Clean and Dirty Water
Tanks before storing.
See Storing Cleaner
on Page 15 for
additional storage
instructions.
13