Replace tank-in-tank^ system, All surface floor cleaner care, Filter; cleaning and replacement – Kenmore 114.85925 User Manual

Page 14: To clean filter, Warning

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

REPLACE TANK-IN-TANK^

SYSTEM

Return filter/float assembly to Dirty Water

Tank. To ensure proper fit, make sure the
arrow on the filter/float assembly lines up
with the Align Filter Front arrow on Tank-

in-Tank™.

ALL SURFACE FLOOR CLEANER CARE

Replace Tank-in-Tank™

System by inserting

bottom first and tilting

forward until tank

latch fastens.

FILTER; CLEANING AND REPLACEMENT

WARNING

To reduce the risk of injury from

moving parts unplug before

servicing.

NOTE:

For best results, clean filter after

each use and replace annually.

TO CLEAN FILTER

Turn unitoff and

unplug from electrical
outlet.

Remove Tank-in

Tank™ System by

pushing down on tank
latch and tilting out

from cleaner.

Grasp tab on

filter/float assembly

and pull up to remove

from tank.

Remove filter from

filter/float assembly by

grasping angled top of

filter and turning
counterclockwise. Lift
filter up and out of
filter assembly.

Remove any loose debris from filter by

tapping the filter against a garbage can.

NOTE:

For additional cleaning, the filter

may be rinsed under water (Diagrams a

and b). Allow filter to air dry completely

before use.