beautypg.com

Changing nozzles, Changing noz, Le$ -11 – Kenmore 114.85925 User Manual

Page 10: Wash and dry, 1 warning

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

WASH AND DRY

step on Nozzle Setting

pedal if necessary to

switch from HARD

FLOOR DRY VAC to

WET SCRUB & VAC

position.

Slide Brush On/Off
switch to the ON

position.

Puli Solution Trigger

to start the flow of

cleaning solution.
NOTE: Cleaner will
continuously dispense
solution untii Soiution

Trigger is released.

With solution On/Off

trigger held down,
slowly push unit

forward. Release

solution On/Off trigger
and pull unit backward
in the same area
cleaned to remove
dirty water and solution
from hard floor.
Overlap strokes by
one inch to prevent
streaking. (For heavily
soiled areas, repeat if
necessary).

IMPOR'

up dirty

to a higli

and mu

ANT: If the unit stops picking

V ater and/or the motor changes

pitch, the dirty water tank is full

be emptied. See page 13.

it

CHANGING NOZZLES

A

1 WARNING

To n «
mov f
serv (

luce the risk of injury from

g parts unplug before

ing.

IMPORfTA'NT: When changing between
hard floor ^d carpet cleaning modes,
make/sure tb use the correct nozzle:

Hard/Ploor Cleaning ~ tangerine nozzle
(witt squeegee)

Carpet Clee ning - green nozzle

(witt out sq jeegee)

Turn Nozzle Lock Tab
counterclockwise to

unlock nozzle from

cleaner.

NOZZLE

LOCK TAB

Pull nozzle forward to
remove completely

from Nozzle Lock.

Store nozzle in Nozzle
Storage Holster and
clip.

10