beautypg.com

Troubleshooting, Warning, Problem possible cause possible solution – Kenmore 114.85925 User Manual

Page 16

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

TROUBLESHOOTING

Review this table to find do-it-yourself solutions for minor performance problems. Any

service needed, other than maintenance described in this Owner’s Manual, should be

performed by a Sears or other qualified service agent.

A

WARNING

Disconnect electrical supply before performing maintenance to the unit.
Failure to do so could result in electrical shock or personal injury.

PROBLEM

POSSIBLE CAUSE

POSSIBLE SOLUTION

All Surface Floor
Cleaner won't
run

1.

Power cord not firmly plugged

Into outlet.

2.

Blown fuse or tripped breaker.

3.

Brush clogged.

4.

Thermal Protector activated.

5.

Needs service.

1.

Plug unit in firmly.

2.

Check fuse or breaker in home. Replace

fuse/reset breaker.

3.

Unplug unit. Remove debris from brushroii

and push brushroii reset button.

4.

Unplug All Surface Floor Cleaner. Allow to

cool for 30 minutes before use.

5.

Take to Sears Service Center.

All Surface Floor
Cleaner won’t

pick up or low

suction

1.

incorrectly assembled.

2.

Clean/DIrty Water Tank not

installed properly.

3.

Dirty water tank is full.

4.

Nozzle clogged

5.

Filter clogged or dirty.

6.

incorrect nozzle attached.

1.

Reassemble All Surface Floor Cleaner.

2.

Secure tank - Pg. 13

3.

Empty Dirty Water Tank - Pg. 13

4.

Clean nozzle opening.

5.

Remove filter and clean - Pg. 14

6.

Attach correct nozzle (tangerine for hard

floors, green for carpets) - Pg. 10-11

Water escaping
from All Surface

Floor Cleaner

1.

Dirty Water Tank la full.

2.

Clean/DIrty Water Tank not

installed properly.

3.

Solution trigger pulled.

1.

Empty Dirty Water Tank - Pg. 13

2.

Secure Tank - Pg. 13

3.

Release solution trigger.

All Surface Floor

Cleaner won’t
dispense solution

1.

Clean/DIrty Water Tank not

Installed properly.

2.

Clean Water Tank empty.

3.

Solution trigger not pulled

1.

Secure Tank.

2.

Fill Clean Water Tank.

3.

Pull solution trigger.

Brushroii not
rotating

1.

Brush On/Off switch not in

ON position

2.

Bnjshroll clogged

3.

Belt broken

1.

Move Brush On/Off switch to ON position.

2.

Unplug unit. Remove debris from brushroii

and push brushroii reset button.

3.

Take to Sears Service Center.

16