beautypg.com

Wash and dry – Kenmore 114.85925 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Fill remainder of Clean
Water Tank with warm
water up to the MAX

FILL line. Replace

measure cap on Clean
Water Tank.

Replace Tank-in-Tank"

System by inserting
bottom first and tilting
forward until tank

latch fastens.

WASH AND DRY

With dry hands, plug
cord into properly
grounded electrical
outlet.

Step on No

2

:zle Setting

pedal if necessary to

switch from HARD

FLOOR DRY VAC to

WET SCRUB & VAC.

Turn cleaner on by
moving power on/off
switch from OFF to
ON.

Step on Handle

Release pedal to put

into cleaning position.

Slide Brush On/Off
switch to the ON

position.

Pull Solution Trigger

to start the flow of
cleaning solution.

NOTE;

Cleaner will

continuously
dispense solution

until Solution Trigger
is released.

With Solution On/Off

trigger held down,
slowly push unit

forward. Release

Solution On/Off

trigger and pull unit

backward in same
area to remove dirty

water and solution
from carpet. (For

heavily soiled areas,
repeat if necessary).

To aid in the drying

process, slide Brush
On/Off switch to OFF
position and continue
operating in WET
SCRUB & VAC mode.

IMPORTANT:

If the unit stops picking up

dirty water and/or the motor changes to a

high pitch, the dirty water tank is full and
must be emptied. See page 13.

12