Kenmore 796.4027 User Manual

Page 24

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Cleaning the Drain Pump Filter

Your Washer is equipped with a filter that helps prevent excess
lint and foreign objects like buttons, keys, and coins from
causing damage to the pump. If the washer fails to drain
properly, unplug the washer and allow the water to cool, if
necessary, before proceeding.

MAINTENANCE (cont.)

3. Remove the plug from the drain hose, and allow the water to

drain completely.

NOTE: If there is a large amount of water in the tub, you may

have to empty your container several times.

2. Unclip the drain hose and pull it out. Place the end of the

drain hose into a shallow pan or a floor drain. Use care not to
pull the hose out too far or it may not drain properly.

4. Twist the pump filter counterclockwise to remove. Remove

any lint and foreign objects from the pump filter.

Reverse the above steps to reinstall the drain pump filter and

drain hose. Be sure to close the cover panel when finished.