Laundry tub drain system – Kenmore 3950144 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

LAUNDRY TUB DRAIN SYSTEM

Check location where washer will be

installed. This washer can be installed
using one of three systems:

• Laundry tub drain system (below)

• Standpipe drain system (p. 12)

• Floor drain system (p. 12)

Do not store or operate washer at or

below 32°F (some water may remain in

washer). See page 31 for Winterizing

Information.

Proper installation is your responsibility.
Make sure you have everything necessary

for correct installation including the
following points:

Grounded receptacle; Must

be within 4 feet of where the

power cord is attached to the
back of the washer.

Hot

and cold water

faucets:

Must provide water pressure

between 5-100 psi and be

within 4 feet of the hot and

of 315 pounds (including washer,

water, and load weight).

washer - 1 inch.

bottom of washer.