Instructions, To activate the oven lockout feature, To reactivate normal oven operation – Kenmore ELITE 790.367 User Manual
Page 19: Press, Display, Setting silent control operation, The delay start and flex clean, U-uu, Setting oven controls (con’t), Oven lockout feature
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Oven Controls (con’t)
Setting
Oven Lockout Feature
The
pad controls the Oven Lockout feature. The Oven Lockout feature automatically locks the oven door and
prevents the Oven from being turned ON. It does not disable the clock, Kitchen Timer or the interior oven lights.
INSTRUCTIONS
To activate the Oven Lockout feature
1. Press and hold for 3 seconds (Figure 1).
2. After 3 seconds
"LOG"
will appear, a beep will sound and
"DOOR LOCKED"
will flash in the display. Once the oven door
is locked the
"DOOR LOCKED"
indicator will stop flashing and
remain on along with the
"LOC".
To reactivate normal oven operation:
1. Press and hold for 3 seconds. A beep will sound. The
"DOOR LOCKED"
will flash in the display until the oven door
has completely unlocked and
"LOC"
has cleared (figure 2).
2. The appliance is again fully operational.
PRESS
^ for
3
seconds
DISPLAY
^for3
seconds
Figure 1
Figure 2
rn
.
pads control the Silent Control operation feature. The Silent Control «1»
operation feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the
control can be programmed for silent operation and later returned to operating with all the normal sounds and beeps.
Setting Silent Control Operation
The
DELAY START
and
FLEX CLEAN
■IMSIRyCIIOMS
To change control from normal sound operation to
silent control operation
.PB.ESS
■DISPLAY
n¿ñn
u-uu
1
.
2
.
3.
To tell if your range is set for normal or silent operation press
and hold
for 7 seconds.
"0:00"
will appear and
"DELAY"
will flash in the display (Figure 3). After 7 seconds
":SP"
will appear in the display (Figure 4).
Press
to switch between normal sound operation and
silent operation mode. The display will show either
":SP"
(Figure 4) o r ( F i g u r e 5).
If
":SP"
appears (Figure 4), the control will operate with normal
sounds and beeps. I f a p p e a r s (Figure 5), the control is in
the silent operation mode.
to reject the
Press
to accept the change or press
change.
for 7 seconds
S
tart
)
or I
Figure 3
Figure 4
Figure 5
19