Before setting surface controls, Locations of the gas surface burners, For models with porcelain cooktop - figure 1) – Kenmore ELITE 790.367 User Manual
Page 10: Before setting surface controis -10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before Setting Surface Controls
Locations of the Gas Surface Burners
(For models with Porcelain Cooktop - Figure 1)
Your range is equipped with gas surface burners with different
BTU ratings. The ability to heat food quicker and in larger
volumes increases as the burner size increases.
The small
SIMMER
burner is best used for simmering delicate
sauces, etc. This burner is located at the right rear burner position
on the cooktop.
The
STANDARD
burner can be used for most surface cooking
needs. This standard burner is located at the left front position on
the cooktop.
The
POWER
burners are best used for bringing large quantities of
liquid rapidly up to temperature or when preparing largerquantities
of food. The 2 POWER burners are located at the right front and
left rear positions on the cooktop.
Regardless of size, always select cookware that is suitable for the
amount and type of food being prepared. Select a burner and
flame size appropriate to the pan. Never allow flames to extend
beyond the outer edge of the pan.
Figure 1
Locations of the Gas Surface Burners
(For models with Ceramic Glass Cooktop - Figure 2)
The
SIMMER
burner is best used for simmering delicate sauces,
etc. This burner is located at the right rear burner position on the
cooktop.
The
STANDARD
sized burnerare used tor most surface cooking
needs. These burners are located at the left front and left rear
positions on the cooktop.
The
POWER
burner is best used for bringing large quantities of
liquid rapidly up to temperature or when preparing largerquantities
of food. This burner is located at the right front position on the
cooktop.
The
BRIDGE
burner is best suited when using rectangular or long
shaped cookware. The left rear and left middle are combined and
controlled by the same control knob. The left front burner may also
be added fora total of 3 burners.
Figure2
10