Kenmore 8519319A - Manual (Page 22)

3. Place wet ítems on top of the rack. Allow space around items
for air to circulate. The rack does not move, but the drum will
rotate. Make sure items do not hang over the edges or
between rack grille.
4, Close the door.
5. Select TIMED DRY and MORE TIME or LESS TIME. Reset
time as needed to complete drying. Refer to the following
table.
6, Select the desired temperature setting to match the fabrics in
your load by pressing TEMPERATURE. Items containing
foam, rubber, or plastic must be dried on a clothesline or by
using the Air Dry temperature setting. Refer to the foilowing
table.
7. Start the dryer.
To remove the dryer rack, lift it straight up and out of the dryer.
NOTE: Check the lint screen and remove any lint accumulated
from items dried on the rack.
Suggested Items for Rack
Drying
Temperature
Setti ng Suggested
Time*
(Minutes)
Washable wool Items (block to
shape and lay flat on rack) Low 20
Stuffed toys (cotton or
polyester fiber filling)
Low 20
Stuffed toys (foam mbber
filled) Air Dry 50
Galoshes (rubber) Air Dry 20
Foam rubber pillows Air Dry 50
Tennis shoes Air Dry 20
’ Reset time as needed to compiete drying.
DRYER CARE
Locatïcjri
Keep dryer area ciear and free from items that would obstruct the
flow of combustion and ventilation air.
AWARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the
floor for a garage installation.
Failure to do so can result in death, explosion,
or fire.
Cleaning the Lint Screen
Every load cleaning
The lint screen is located in the door opening of the dryer. Clean it
before or after each ioad. A screen blocked by lint can increase
drying time.
To clean
1. Puil the lint screen straight up. Roli lint off the screen with
your fingers. Do not rinse or wash screen to remove lint. Wet
lint is hard to remove.
2. Push the lint screen firmly back into piace.
IMPORTANT:
■ Do not run the dryer with the lint screen loose, damaged,
blocked, or missing. Doing so can cause overheating and
damage to both the dryer and fabrics.
■ Some towels made of synthetic fibers and naturai fibers
(polyester and cotton blends) may shed more lint than other
towels, causing your dryer’s lint screen to fill up faster. Be
sure to remove lint from the lint screen before and after drying
new towels.
■ If lint falls off the screen into the dryer during removal, check
the exhaust hood and remove the lint. (See “Venting
Requirements.”)
22