Kenmore 8519319A - Manual (Page 21)

Use Modifiers to select temperatures for the Manual Cycles.
Press Temperature until the desired temperature setting glows.
Temperature modifiers cannot be used with the Auto Dry Cycles.
• H igh
• M edium H igh
• M edium
• Low
• EXIRALOW
• air DRY
T emperature
(MAHUALCrClESONLYI
Air Dry
Use the Air Dry Modifier for items that require drying without heat
such as rubber, plastic and heat-sensitive fabrics. This table
shows examples of items that can be dried using Air Dry.
Type of Load Time*
(Minutes)
Foam rubber - pillows, padded bras, stuffed toys 2 0 - 3 0
Plastic - Shower curtains, tablecloths 2 0 - 3 0
Rubber-backed rugs 4 0 - 5 0
Olefin, polypropylene, sheer nylon 1 0 - 2 0
* Reset cycle to complete drying, if needed.
When using Air Dry
■ Check to see that coverings are securely stitched.
■ Shake and fluff pillows by hand periodically during the cycle.
■ Dry item completely. Foam rubber pillows are slow to dry.
NOTE: Air Dry is not available with Auto Dry Cycles.
You can change Auto Dry and Manual Cycles, Options and
Modifiers any time before pressing Start.
■ Three short tones sound if an unavailable combination is
selected. TTie last selection will not be accepted.
Changing Cycles after pressing Start
1. Press PAUSE/CANCEL twice.
2. Select the desired cycle and options.
3. Press and hold START. The dryer starts at the beginning of
the new cycle.
NOTE: If you do not press Start within 5 minutes of selecting the
cycle, the dryer automatically shuts off.
Changing Options and Modifiers after pressing Start
You can change an Option or Modifier anytime before the
selected Option or Modifier begins.
1. Press PAUSE/OANCEL once.
2. Select the new Option and/or Modifiers.
3. Press and hold START to continue the cycle.
NOTE: If you happen to press Pause/Cancel twice, the program
clears and your dryer shuts down. Restart the selection process.
End of Cycle Signal
The End of Cycle Signal produces an audible sound when the
drying cycle is finished. Promptly removing clothes at the end of
the cycle reduces wrinkling.
• HIGH
• Low
■ OFF
END of CYCLE SIGfUL
Press END of CYCLE SIGNAL to adjust the sound level or turn off
the signal.
NOTE: When WRINKLE GUARD® is selected and the End of
Cycle Signal is on, a tone sounds every five minutes until the
clothes are removed, or WRINKLE GUARD® ends.
rc
The dryer rack is shipped in place in your dryer. Remove and
discard any packing material before use.
Use the TUMBLE FREE'''^ Heated Dryer Rack for items that you
do not want to tumble dry, such as sweaters. When you use the
heated dryer rack, the heated air inside the dryer flows in a
concentrated pattern to allow efficient and uniform drying. Use
Timed Dry to select the desired time.
To use the heated dryer rack:
Do not remove the lint screen.
1. Open dryer door.
2 . Place dryer rack over the bottom of the dryer door opening.
Rest the back wire on the dryer back ledge. Push down on
the frame front to secure over lint screen.
21