Kenmore 8519319A - Manual (Page 16)

Reverse llie door handle
1. Place the outer door assembly face down on work space.
2, Remove the 2 screws that hold the door handle and the 2
screws holding the hole plugs. If hole plugs do not easily fall
out after screws are removed, insert a small screwdriver into
the holes and gently push the plugs out.
5.
3.
4.
Move the door handle to the other side and reattach.
Move the hole plugs to the new hinge side and attach with
screws.
Reinstalling the door
1. Check for fingerprints on the glass. Clean if necessary.
2. Place the inner door assembly into the outer door assembly.
Align the hinge cover and hinge in the openings on each side.
To fit correctly, the inside door assembly edge is completely
inside the outside door assembly edge.
3. Reassemble the inner and outer door assemblies with the 6
screws.
4, Use a small flat-head screwdriver to remove hole plugs in the
door opening. Slide the head of the screwdriver under the
cap of each hole plug, being careful not to scratch the dryer
surface. Lift up. Remove the hole plugs in the door opening
and insert in the opposite side.
Insert a screw in the 2nd opening from the top of the hinge
opening and partially tighten. Hang the door by placing the
top hinge keyhole over the 2nd screwhead and tighten the
screw. By putting this screw in first, the door wiil hang in
place while you insert and tighten the remaining 4 screws.
6. Close the door and check that it latches securely.
if laiciilcfliOf I
Check to be sure all parts are now installed. If there is an
extra part, go back through the steps to see which step was
skipped.
Check to be sure you have all of your tools.
Dispose of all packaging materials.
Check the dryer’s final location. Be sure the vent is not
crushed or kinked.
Check to be sure the dryer is level. (See “Level Dryer.”)
Plug into a grounded outlet. Turn power on.
Remove the blue protective film on the console and any tape
remaining on the dryer.
Read “Dryer Use.”
Wipe the dryer drum interior thoroughly with a damp cloth to
remove any dust.
10. Set the dryer on a full heat cycle (not an air cycle) for 20
minutes and start the dryer.
If the diyer will not start, check the following:
■ Controls are set in a running or “On” position.
■ Start button has been pushed firmly.
■ Dryer is plugged into a grounded outiet.
■ Electricai supply is connected.
■ House fuse is intact and tight; or circuit breaker has not
tripped.
■ Dryer door is closed.
11. When the dryer has been running for 5 minutes, open the
dryer door and feel for heat.
If you do not feel heat, turn the dryer off and check the
following:
■ There may be 2 fuses or circuit breakers for the dryer. Check
to make sure both fuses are intact and tight, or that both
circuit breakers have not tripped. If there is still no heat,
contact a qualified technician.
NOTE: You may notice a burning odor when the dryer is first
heated. This odor is common when the heating element is first
used. The odor will go away.
16