Kenmore 911.46565 - Manual (Page 12)

ÍLMmííi
OPERATION
Oven Control, Clock and Timer
TONES
new eontrol has a series of tones
that will sound at different tirnes, These
tones rnay sound while you set the
control for an oven function, or at the
end of the oven function, ft will also alert
you that there rnay be a problem with
the functions. Below are the types of
tones and a brief description of each,
TONES WHILE SETTING THE
CONTROI- - When you press a touch
pad you will hear a beep. This beep will
let you know you have placed enough
pressure on the pad to activate it. (The
arrow pads do not beep.)
END OF TIMED CYCLE TONE - At
the end of an automatic timed cooking
function, you will hear 3 short beeps
followed by 1 beep every 6 seconds.
This 6 second beep will continue to
sound until the CLEAR/pFF pad is
pressed or you may select the special
feature to cancel this 6 second beep
from sounding at the end of future
cycles.^
/■■■ ' ■■■:
TO CANCEL THE 6 SECOND
'BEEF '
1. Press and hold the BAKE and
BROIL pads, at the same time
for 3 seconds, until the display
ehpWS;f«SF.”; ^
2. Press the KITCHEN TIMER
ON/OFFpad. The display will show
"CON BEEP** (continuous beep).
3. Press the KITCHEN TIMER
ON/OFF pad again. The display will
show «BEEP» (beep canceled).
4. Press the START pad to cancel the
6 second beep and leave the
special feature mode.
If you would like to return the 6 second
beep, repeat steps above until the
display shows your choice and préss
'the START pad^'''-"''f:', yl'T'
ATTENTION TONE - This tone will
sound if yOu make an error or an
oversight is made while Setting an
oven function.
■
Examples would be: ^
a. Setting a clean cycle and the oven
door is not properly closed.
b. Setting function and not pressing the
START pad. „ , ' ; ^ ,
c-Pressing an additional function
pad without first setting a
ternperature or time.
el. “ÉRR» will flash if you set an invalid
" "'temperature. Press the CLEAR/OFF
pad to clear the control and reset
your oven function.
Any of these can be quickly identified
by watching the display.
PREHEAT TONE ^ When you
set an oven temperature, the oven
automatically starts to heat. When the
temperature inside the oven reaches
the temperature you have set, a tone
will sound to let you know the oven is
ready for baking.
FCODE
If you set an oven fqnotion and the
control beeps while the display is
flashing "F” and a number or letter
such as “F4” or “FI,” there may be a
problem with the control or oven.
Simply press the CLEAR/OFF pad and
wait about an hour. Try setting the
function again. If the code repeats, write
down the flashing code and call for
service. Tell the technician what code
was flashing.
12