Cisco OL-5742-01 - Manual (Page 13)

18-13
Cisco Signaling Gateway Manager User Guide
OL-5742-01
Chapter 18 Configuring SGM Security
Configuring SGM User-Based Access
If you have enabled this function and you want to disable it (that is, prevent SGM
from forcing users to change passwords), enter the following command:
# ./sgm passwordage clear
Note If sgm authtype is set to solaris, you cannot use the sgm passwordage
command. Instead, you must manage passwords on the external
authentication servers.
Step 7 (Optional) You can configure SGM to disconnect an SGM or GTT client
automatically after a specified number of minutes of inactivity. To do so, enter the
following command:
# ./sgm clitimeout number-of-minutes
where number-of-minutes is the number of minutes an SGM or GTT client can be
inactive before SGM disconnects the client.
The valid range is 1 minute to an unlimited number of minutes. There is no default
value.
This function is disabled by default. If you do not specify the sgm clitimeout
command, clients are never disconnected as a result of inactivity.
If you have enabled this function and you want to disable it (that is, never
disconnect a client as a result of inactivity), enter the following command:
# ./sgm clitimeout clear