CITIZEN S4000DCM - Manual (Page 37)

— 34 —
5.6 Full cutting label paper *L
When full-cutting the label paper with the printer installed horizontally,Be sure
that the guide plate is mounted on the paper exit of the printer cover.
(This guide plate was set to the printer at the time of factory shipment.)
The Guide Plate prevents cut paper from dropping in the printer.
CAUTION!
■ If about 10 sheets of cut paper accumulate on the paper exit, remove the paper.
• Stacking of 10 or papers, paper jam may occur.
■ Remove the guide plate in other than full-cutting label paper with the printer set
horizontally.
• The manual cutter cannot be used when the guide plate is mounted.
• Short label paper with the printer set vertically may be hard to exit.
●Mounting and Dismounting Guide Plate
• Mounting
With the printer cover kept open, insert the tabs of the guide plate to the two
mounting holes (either right or left hole) located at the inside of the cover front. Set
the guide plate with its lib facing toward you.
Then, with the guide plate warping toward you, insert the tabs to the two mounting
holes at the opposite side of the cover.
• Dismounting
With the printer cover kept open, pull the center portion of the guide plate toward
you to remove the guide plate.
Tabs for
mounting hole
Lib
Warp toward you
Set similarly at the
opposite side.