GE 2-9876 - Manual (Page 8)

INSTALLATION
Follow these steps to set-up your new Desktop GE Model
2-9876 Answerer for proper operation.
1. Install the 9 Volt Battery
The 9 volt battery will provide back up power durirtg
temporary power outages. Using a pointed object, insert
in opening of battery compartment on bottom of BASE
and pop up. Insert battery and snap into place. Replace
battery cover.
2. Connect the Line Cord
Plug one end of the telephone line cord into the *'TO
WALL OUTLET" jack at the rear of the unit. Plug the
other end into the telephone outlet. An RJllC or an
RJ14C (two line) outlet jack is required. If you don't have
this type of outlet jack, an adapter can be purchased
from any telephone store.
Note: If a two line system is used the answerer will provide
both signals to the "FROM TELEPHONE” jack but will only
answer calls on Line One.
A.
Setting Up
The
Answerer
3. Connect your Telephone (If you do not want to connect
a telephone to the Answerer, go to step 3.) Plug your
telephone cord to the "FROM TELEPHONE” jack at the
rear of the unit.