GE 2-9876 - Manual (Page 23)

REMOTE OPERATION
The GE 2-9876 Answerer has been programmed to be “user
friendly” while you are away from home. For your
convenience, remove the remote wallet card (attached to the
back of this guide), fill in security code from bottom of unit.
arHj store in your wallet or purse for reference when you use
remote functions.
5.
When you call from a remote touch tone phone
1. Listen to your OGA or bypass it by pressing any key.
Wait for a transfer tor>e (long beep).
Enter your 3-digit security code. (The factory preset
number written on the bottom of the unit.)
The VOICE will tell you the total number of messages
from all mailboxes, then you will hear another 3 short
beeps.
Whenever the 3 beeps play, the unit will wait 3
seconds for commands. If none are entered, the unit
will start voice MENU (as a reminder of the menu
command). The unit will then allow 7 more seconds
for a commarKJ. if none are entered the unit will hang
up-
Pressing '9' will begin the voice MENUS. Further
pKessing of ‘9‘ will advance to the next MENU pages.
There are a total of 5 MENU pages. Each MENU is
ended with the three short beeps prompt.
At the completion of any function, you will again hear
3 beeps meaning the answerer is awaiting your next
command. 7.
Note: Vbu may enter arty function number at any time.
You don't have to listen to the entire menu nor do you
have to be in the menu where the desired rentote
function is located.
8. if an invalid commartd is entered, the unit will play the
3 short beeps prompt.
Note: There may be times when you will encounter
phone line disturbances, or “noise on the line". These
disturbances may interfere with the clear transmission of
your touch tone keypad commands. If you suspect this to
be occurring, press ♦ (star button) from the remote
location to “silerKe” the unit. Then enter your remote
commarKf.
c.
Using The
Remote
Voice
Menus
23