beautypg.com

The cancel/drain pad, Control panel lock-out feature, To use the lock-out feature – Whirlpool 9400 User Manual

Page 9: To turn off the lock-out, Feature, Adjusting the beeping sound, To turn off the beep, To turn the beep back on

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

U S I N G Y O U R D I S H W A S H E R

The CANCEL/DRAIN pad

CANCEL/

DRAIN

The CANCEUDRAIN pad allows you to cancel a cycle, to clear the signal lights or to

make a new selection.

Press CANCEUDRAIN while the dish­

washer is washing to start a 2 minute drain.
(If the dishwasher has not been started or
is not washing, it will clear the display.)

Press CANCEUDRAIN again to stop the

drain.

Press CANCEUDRAIN again to start a

2 minute drain, if there is still water in the
dishwasher.

,

NOTE: A small amount of water remaining
in the dishwasher is normal. See page 27.

Control panel lock-out feature

This feature lets you lock-out the function of the control pads (except to cancel or pause a
cycle that is running). When the control panel is locked-out, the dishwasher cannot be started

and a running cycle cannot be changed.

To use the lock-out feature

1. Press and hold the OPTIONS and DEU^Y

pads until the CLEAN signal light flashes.

2. Release the pads. The CLEAN signal light

will stop flashing.

To turn off the lock-out
feature

1. Press and hold the OPTIONS and DELAY

pads until the CLEAN signal light turns on
and stays on.

2. Release the pads. The CLEAN signal light

will turn off.

PRESS

OPTIONS ■ DELAY

YOU SEE

PRESS

OPTIONS ■ DELAY

Adjusting the beeping sound

Each time a control pad is pressed, a single “beep" sound is made. A double beep means one
of the extra features was selected (such as control panel lock-out) or the wrong control pad
was pressed.

To turn off the beep

1. Press and hold the OPTIONS pad until the

CLEAN signal light flashes.

PRESS

2. Release the pad. The CLEAN signal light

will turn off.

YOU SEE

OPTIONS

NOTE: A power failure will reset this feature.
You will have to repeat the above steps.

To turn the beep back on

1. Press and hold the OPTIONS pad until the

CLEAN signal light turns on and stays on.

2. Release the pad. The CLEAN signal light

will turn off.

PRESS

OPTIONS

YOU SEE