Whirlpool 9400 - Manual (Page 5)

P A R T S A N D F E A T U R E S « U S I N G Y O U R D I S H W A S H E R
Control panel
Signal lights
Using Your Dishwasher
In This Section
Page Page
Using your dishwasher for the first Tf e WATER HEATING signal light .10
time................... ................................... .5
Tf e CLEAN signal light.......................... .10
Before starting your dishwasher .... .6
Flashing signal lights.............................. .11
Starting your dishwasher......................... .6
Cycle selection chart.............................. .11
Starting your dishwasher using
delay wash............................................. .6
W iat happens in each option.................. .12
Using cycle pause.................................. .7 Ui ing the detergent dispenser................. .14
Changing a cycle setting.......................... .8
U£ ing the rinse agent dispenser.... .15
Adding a dish during a cycle..................... .8
Quiet operating tips................................ .16
The CANCEL/DRAIN pad....................... .9 Water temperature tips........................... .17
Control panel lock-out feature.................... .9
Erergy saving tips.................................. .17
Adjusting the beeping sound..................... .9 Special tips on dishwasher use............... .18
Operating your dishwasher properly enables you to obtain the best possible results. This
section explains proper dishwasher operation.
Using your dishwasher for the first time
When your dishwasher is first
installed, the signal lights will
flash rapidly in order. The
signal lights will also flash
after a power failure. Press
the CANCELVDRAIN pad twice to clear the
signal lights.
Five control pads and the signal lights
allow you to set and check the
dishwasher’s function.
“beep" sounds each time a pad is
pressed under normal conditions.
The dishwasher is preset for the Normal
c/cle with the Heat Dry option. After each
use, the dishwasher remembers the last
cycle and options used. The next time the
d splay is lit up for selection, it will show
ttie last selection that was used.