Whirlpool 9400 - Manual (Page 28)

I F Y O U N E E D A S S I S T A N C E O R S E R V I C E
PROBLEM CHECK THE FOLLOWING
White residue appears
on front of access
panei Is too much detergent being used? See pages 14 and 15 for
recommended amounts of detergent.
Some liquid detergents develop excess foam and build up on
access panel. Try a different brand to reduce foaming and
eliminate build-up.
WATER HEATiNG
signai iight flashes Is the water supply less than 120°F (49°C) when it enters the
dishwasher? See pages 10 and 17.
Control panel does not
work Is the door open?
Is the cycle pause feature on? See page 7.
Is the control panel lock-out feature on? See page 9.
All signal lights flash
and the dishwasher
stops or will not run Has there been a power failure? See page 11.
Control panel does not
“beep” when pads are
pressed Is the control panel lock-out feature on? See page 9.
Dishwasher drains
after turning off
CLEAN signal light
and/or closing the
door
Did you accidental press the CANCEL/DRAIN pad while
closing the door? Press CANCEL/DRAIN pad again to stop
draining. Restart cycle if needed.
28