Whirlpool 9400 - Manual (Page 6)

U S I N G Y O U R D I S H W A S H E R
Before starting your dishwasher
1. Properly load the top rack, bot­
tom rack, silverware basket, and
the cutleiy basket. See pages
19-22.
2. Spin both spray arms with both
racks in place to make sure noth­
ing prevents arms from turning
freely.
3. Add detergent. See pages
14 and 15.
4. Checkthe rinse agent dispenser.
See pages 15 and 16.
5. Push door firmly when closing
and it will automatically latch.
Avoid touching control pads
while door is open or being
closed.
6. Run hot water at sink nearest
dishwasher until water is hot.
Turn off water.
Starting your dishwasher
The dishwasher will wash and dry dishware according to the selections you make on the
control panel.
1. Press the START pad once to display the
cycle and options. Skip to Step 4 if you
want to run the cycle and options shown
by the lights.
2. Press the CYCLE pad until the cycle you
want is indicated by a signal light. Each
press of the CYCLE pad advances the
signal light to the next cycle.
3. Press the OPTIONS pad until the option
you want is indicated by a signal light.
Each press of the OPTIONS pad ad­
vances the signal light to the next option.
4. Press the START pad again.
NOTE: Cycle and option selections are
canceled by a power failure.
PRESS
PRESS
PRESS
OPTIONS
PRESS
Starting your dishwasher using delay wash
The DELAY pad allows you to delay the start of a cycle for 2, 4, or 6 hours after loading the
dishwasher. For example, use DELAY to run the dishwasher during off-peak hours of
electrical use.
1. Press the DELAY pad once to display the PRESS
last cycle and options selection.