beautypg.com

The water heating signal light, The clean signal light – Whirlpool 9400 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

U S I N G Y O U R D I S H W A S H E R

WATER HEATING

The WATER HEATING signal light

The WATER HEATING signal light comes
on during the water heating portion of the

Pots & Pans cycle. The signal light will also

come on during the water heating portion of
other cycles when the Hi-Temp option is
soloctod

The WATER HEATING signal light will

flash at the end of the cycle if the water did

not heat to 135“F (57°C). If you want to
make sure the water gets heated to 135°F
(57“C), use the Hi-Temp option (see
page 13).

When the signal light is on, water is being

heated. The heating time is based on the

temperature of the water supply as it enters
the dishwasher. The cooler the water, the

longer the heating time. The WATER
HEATING signal light will go off when the
water temperature reaches 135“F (57“C).

The CLEAN signal light

The CLEAN signal light comes on at the end
of a cycle to show that the load is clean. It
will stay on until CANCEL/DRAIN or any
other control pad is pressed.

As an option, you can have the CLEAN

light turn off the first time you open the door
after a cycle is Tmished;
1. Press and hold the CYCLE pad until the

CLEAN signal light starts flashing.

2. Release the pad. The CLEAN signal light

will turn off.

NOTE: A power failure will reset this feature.

You will have to repeat the above steps.

To have the signal light stay on again when
the door is opened:

1. Press and hold the CYCLE pad until the

CLEAN signal light turns on.

2. Release the pad. The CLEAN signal light

will turn off.

CLEAN

PRESS

YOU SEE

■CLEAN

PRESS

YOU SEE

CLEAN

10