Carl Goldberg GBGA1053 - Manual (Page 2)

ITEMS NEEDED TO COMPLETE THIS AIRCRAFT
1 RADIO GUIDANCE SYSTEM (4 CHANNEL
MINIMUM REQUIRED)
2 12” AILERON SERVO EXTENSION WIRES
1 Y-HARNESS
1 ENGINE .60-.90 2-CYCLE, .90-1.20 4-
CYCLE AND MUFFLER
1 2 OZ. BOTTLE CA GLUE
1 1/2 OZ. BOTTLE CA GLUE
1 EPOXY
1 8 x 12 FOAM RUBBER
OPTIONAL:
1 PILOT FIGURE
1 SWITCH HARNESS
*
NOTE: The Ultimate ARF covering matiches
Bright Yellow(#872), Deep Blue(#873)
UltraCote®.
UltraCote® is a registered trademark of Horizon Hobby Distributors
TOOLS AND SUPPLIES FOR ASSEMBLY .
MODELING OR UTILITY KNIFE
WORK SURFACE (24" X70")
ELECTRIC DRILL
1/16”, 3/32”,1/8", 3/16”, 5/32”, 1/4”, 5/64”
7/32” DRILL BITS
SMALL STANDARD & PHILLIPS SCREW-
DRIVERS
MASKING TAPE
NEEDLE NOSE PLIERS
MOTO TOOL
24” RULER
FLEXIBLE STRAIGHT-EDGE
30-60-90° x 6" TRIANGLE
SOFT PENCIL
A FEW STRAIGHT OR "T" PINS
ADJUSTABLE WRENCH
WIRE CUTTER (DYKES)
OPTIONAL HEAT GUN/COVERING IRON
ACID BRUSH
ELECTRICAL TAPE
SOLDERING IRON, FLUX, SOLDER
PIECE OF MEDIUM SANDPAPER
5 FT. LENGTH OF STRING
2