Carl Goldberg GBGA1070 - Manual (Page 10)

EX-TREME 330 3-D ARF
35. Drill the holes for the gear, then install the gear
using the 3mm x 30mm bolts and lock nuts.
36. Install the axles in the end of the landing gear
using the 4mm lock nuts.
37. Install the first collar and set screw on the axle.
38. Install the large wheel, then the second collar and
set screw to secure the wheel. Leave a small
amount of space from the wheel hub to allow the
wheel to turn freely. Use thread lock on the set
screws.
39. Lay out the parts for the fuel tank assembly.
Check the tank for any debris inside, then check
the fit of the stopper. You may need to remove
some flash with a sharp hobby knife.
40. Bend the long fuel tube so 1/3 of it is bent up at
45 degrees.
41. Assemble the stopper as shown, with the small
washer to the inside of the stopper, then the
stopper, and the large washer. Secure with the
machine screw. Just start the screw for now.
© 2002 Carl Goldberg Products, Inc.
Page - 10