Carl Goldberg GPMA0963 Cub - Manual (Page 10)

10
12a. Place fuse sides one on the other, tape rear
together around the back end. Spread fuse fronts apart,
and plug former “C” into holes in body sides. Hold parts
together with a rubber band.
12b. Hold fuse tail end up, carefully spread fuse rear
open,and plug former “G” in place, hold with a rubber
band. Working towards front, install formers “F”, “E”
and “D” in same manner, using rubber bands to hold
parts.
12c. With die-cut separation facing out, insert bottom
sheet under rubber bands at former “C”, and work it
towards tail, slipping it under bands as you go.
12d. Lock tabs at sides and ends of bottom sheet into
corresponding notches in fuse sides. Hold parts with
tape.
12e. Working through former C, position top sheet in
same manner, sliding it towards rear.
12f. Position stab platform between fuse ends, and hold
parts in place with tape or rubber bands.
13. Position front bottom sheet and tape it securely to
fuse at rear only as shown.
14. Install firewall and pull fuse fronts toghether with tape
as shown.