CAMCORP Fabricated Rotary Airlock - Manual (Page 3)

CAMCORP, INC.
9732 Pflumm Road Lenexa, Kansas 66215 Phone: 913-831-0740 Fax: 913-831-9271
www.camcorpinc.com
Section 1 – Safety Recommendations
It is the owner’s responsibility to maintain the safety features included with this
equipment. The safety features may include, but not necessarily be limited to:
guards, access doors and covers, warning decals, caution decals, and advisory
decals. Replacement features are available from CAMCORP.
Do not attempt to operate this equipment until you have read and understand the
contents of this manual. If you do not understand the contents of this manual bring
it to the attention of your supervisor. This manual contains important safety
instructions concerning the maintenance, use and operation of this product.
Failure to follow these instructions may result in serious injury or death.
( )**) ) + , -) ). (/
Be sure that the motor is wired for the correct rotation. Rotation should be counter
clock wise when standing in front of the chain guard. This airlock must be wired
and grounded in accordance with all applicable codes.
Check lubrication level only when airlock is stopped.
Do not operate this equipment without guards, access doors and covers secured.
Keep chain properly tensioned and aligned.
Lock out power before servicing this equipment.
This equipment is automatically controlled and will start at any time without
warning.
Finger guards should be installed on airlocks that discharge into drums or open
containers. The inlet and outlet of the airlock must be inaccessible.
Failure to follow these instructions may result in personal injury or property
damage.
1-1