Cadillac 2010 DTS - Manual (Page 262)

For the Bose amplified radio, perform the following
steps to setup the equalization settings:
1. Press the a knob until the DSP label displays.
2. Press the pushbutton located under the DSP label
to get choices of Norm, Driv, Rear, and Surround,
to display.
3. Press the pushbutton located under the desired
setting.
To select Surround, press either the fourth or
fifth pushbutton located under the displayed
Surround until Centerpoint displays.
To return to the manual mode, press the tune knob.
Select either BASS, MID, or TREB and start to manually
adjust the settings by turning the
a knob.
Adjusting the Speakers (Balance/Fade)
BAL/FADE (Balance/Fade): To adjust balance or
fade, press the
a knob until the speaker control labels
display. Continue pressing to highlight the desired
label, or press the pushbutton positioned under the
desired label. Turn the
a knob to adjust the highlighted
setting. The highlighted setting can be adjusted by
pressing either SEEK arrow,
\ FWD, or s REV
buttons until the desired levels are obtained.
To quickly adjust balance or fade to the middle position,
press the pushbutton positioned under the BAL or
FADE label for more than two seconds. A beep sounds
and the level adjusts to the middle position.
To quickly adjust all speaker and tone controls to the
middle position, press the
a
knob for more than
two seconds until a beep sounds.
Digital Signal Processing (DSP)
This feature is used to provide a choice of four different
listening experiences. DSP can be used while listening
to the audio system or a CD. To change the DSP mode,
press the
a knob until the DSP control label displays.
Press the pushbutton located under the DSP label
until the control labels display. Continue by pressing the
desired button below the control labels on the display.
For more information on the control label displays,
see the following:
• Norm (Normal): Select this screen button to adjust
the audio for normal mode. This provides the best
sound quality for all seating positions.
• Driv (Driver): Select this screen button to adjust
the audio for the driver to receive the best
possible sound quality.
4-96