BMW 2012 X6M User Manual
Page 219
▷
"Audio"
7.
"OK"
If a function has already been assigned to an‐
other connected device, the function is deacti‐
vated in that device and the device is unpaired
when the function is assigned to a new device.
Swapping the telephone and additional
telephone
The function of the telephone and additional tel‐
ephone can be swapped automatically.
1.
"Telephone"
2.
"Bluetooth® (phone)"
3.
"Swap phone/addit. phone"
Unpairing a device
1.
"Telephone"
2.
"Bluetooth® (phone)"
3.
Highlight the device that is to be unpaired.
4.
Open "Options".
5.
"Remove phone from list"
What to do if...
Information on suitable mobile phones, refer to
page
.
The mobile phone could not be paired or con‐
nected.
▷
Is Bluetooth activated in the vehicle and on
the mobile phone? Activate Bluetooth on
the vehicle and on the mobile phone.
▷
Do the Bluetooth passkeys on the mobile
phone and the vehicle match? Enter the
same passkey on the mobile phone and via
iDrive.
▷
Did it take longer than 30 seconds to enter
the passkey? Repeat the pairing procedure.
▷
Are too many Bluetooth devices connected
to the mobile phone or vehicle? Delete con‐
nections with other devices if necessary.
▷
Is the audio connection activated? Deacti‐
vate the audio connection.
▷
Is the mobile phone in power-save mode or
does it have only a limited remaining battery
life? Charge the mobile phone in the snap-
in adapter* or via the charging cable.
▷
Depending on the mobile phone, it is possi‐
ble that only one device can be connected
to the vehicle. Unpair the connected device
from the vehicle and pair and connect only
one device.
▷
The mobile phone no longer reacts? Switch
the mobile phone off and on again. Repeat
the pairing procedure.
The telephone functions are not available.
▷
Is the mobile phone paired as an additional
telephone and is the additional telephone
function deactivated? Activate the function.
▷
Is an outgoing call not possible? Connect
the mobile phone as a telephone.
No phone book entries or only some phone book
entries are displayed, or they are incomplete.
▷
Transmission of the phone book entries is
not yet complete.
▷
It is possible that only the phone book en‐
tries of the mobile phone or the SIM card*
are transmitted.
▷
It may not be possible to display phone book
entries with special characters.
▷
The number of phone book entries to be
stored is too high.
▷
Is the data volume of the contact too large,
e. g., due to stored information such as
notes? Reduce the data volume of the con‐
tact.
▷
Is the mobile phone connected as an audio
source or additional telephone? The mobile
phone must be connected as a telephone.
The phone connection quality is poor.
Seite 219
219
Online Edition for Part no. 01 40 2 606 735 - 03 11 500