Blinds Chalet EcoGreen Solar Screen Shades - Manual (Page 3)

3.
3) Install the Tension Device
The tension device reduces the hazards of strangulation and entanglement of
young children or pets by limiting access to the control cord. Anchor the
tension device that is attached to the shade’s control cord to the window frame
or wall so that young children or pets cannot pull the cord around their necks.
a. Lower the shade.
b. Hold the tension device upright so the warning tag hangs straight down
as shown in diagram.
c. Position the tension device on the window frame or the wall so that
the tension device and control cord do not interfere with raising or
lowering the shade. The tension device should be installed without
stretching or pulling down on the control cord. Stretching the cord
will cause excessive wear. Do not twist or cross the control cord.
d. Holding the tension device upright, and in position, as shown, insert and
secure the screw through the hole. The mounting screw must be
secured into a solid surface or molly.
4) Operate the Shade
Operate the shade by pulling down on one side of the cord - one side of the cord raises
the shade, the other side lowers the shade. Do not lift the bottom rail with your hands.
Also, be careful not to place objects on the window sill that will interfere with operating
the shade or cause it to hang unevenly.
5) To Remove a Shade
To remove a shade, from the bottom rear of the headrail insert a flathead screwdriver in
between the headrail and bracket. Gently twist the screwdriver and pry open the bracket
to release the headrail. As you release the brackets, support the headrail to keep it from
falling.
1) Mount the Brackets
The open end of each bracket faces downward, as shown in the drawing below.
NOTE: If you have an inside mount and must use inside mount holes, you will have to drill
your own holes in the side of the bracket. Use at least two screws per bracket, and make
sure that the screw heads clear the clutch
.
Fascia Panel Installation
V
Lug
Blade