Avlink SX-2088 - Manual (Page 24)

SX Matrix Switching System—User Manual
23
7.0.2.1 Main Operation Interface Features
Refer to the window menu above, the interface blue area shows crossing matrix of output
ports 01-08 and input ports of 01-08. On the lower right hand corner, you can select either
“Video” for signal input switching or “Disconnect”to close all output ports. Click to check the
white box to the left of “Video” or “Audio” for video or audio signal transimission.
Examples for Selecting Matrix Switching Functions:
Example 1: Now there is a SX-2088 matrix having all the input/output ports properly
connected to the equipment. There are two ways of operation if you want to set channel 1
audio/video to channels 2, 3 and 5 for output and channel 3 audio/video to channel 6 for output:
First way: Make sure you have selected“Video＂and“Audio＂ by checking the white
boxes to the left. Directly click on the corresponding icons on the matrix to turn them into
to complete the switching operation.
Second way:
Step 1: Make sure you have selected “Video” and “Audio” by checking the boxes to the left.
Step 2: First select the “Output”number keys 02, 03 and 05 to the right, and select the “Input”
number key 01 to the bottom. Afterwards, press consecutively the previously selected “Output”
number keys 02, 03 and 05 (or you can press the “Deselect all output” key). This way, you have
selected “Input” 01 and “Output” 02, 03 and 05 switching.
Step 3: First select the “Output” number key 06 to the right, and select the “Input” number
key 03 to the bottom. Afterwards, press the previously selected “Output” number key 06 (or you
can press the “Deselect all output” key). This way, you have selected Input 03 and Output 06
switching.
Upon completion of the above 3 steps, you have actually completed the switching operation of
having Audio/Video channel 1 to Output channels 2, 3 and 5 while at the same time successfully
switched from Audio/Video channel 3 to Output channel 6.
Example 2: Now, there is a SX-2088 matrix with the input/output ports properly connected to
the equipment. It is required to set the input/output connectors to switching from audio/video
channel 1 to output channels NO.1, 6 and 7 and also to switch from audio/video channel 2 to
output channel 8. There are two ways of operations:
First Way:
Step 1: Make sure you have selected “Video” and not “AUDIO”. Directly click on the icons
on the matrix corresponding to the INPUT number key 01 and the OUTPUT number keys 01、
06、07 to turn into ，you have then selected video switching of input 01 and output
01,06,07.