Antari X-510 PRO - Manual (Page 5)

5
Optional Accessories:
1. Hanging bracket
2. Drip tray
3. X-30PRO Wireless Control Module
4. FX-510, FX-515 Flightcase
Before beginning with the initial setup of your X-PRO SERIES Fogger, make sure that there is no
evident damage caused by transportation. In the event that the unit's housing or cable is damaged,
do not plug it in and do not attempt to use it after having contacted your Antari dealer for assistance.
Setup
1. Remove all packing materials from shipping box. Check that all foam and plastic padding is
removed, especially in the nozzle area.
2. Place fog machine on a flat surface and remove fog liquid tank cap.
3. Fill unit about 3/4 full. Use Antari Fog Fluid only. Antari X-510PRO and X-515PRO Foggers only
work with uncontaminated Antari FLG/FLR Fog Fluid. Other fluids may cause possible clogging
problems and could result in the production of unhealthful fog. The use of other fluids will void the
warranty of the Antari X-510PRO and X-515PRO. When filled, place cap back on liquid tank.
Operation
* The plug is at a position that is accessible when the machine is in use.
Plug power cord into a grounded electrical outlet. Turn power switch on the rear of unit to “ON”
position. Warm-up is completed when the display on control module shows “Ready to Fog”.
* To emit fog, press the appropriate button on the X-10PRO Control Module for the desired length
of time.
* The Control Module’s display will cycle “Warming up” and “Ready to Fog” while the machine
re-heats to the proper operating temperature.
* When the fluid is running low, the LED inside the tank chamber starts blinking until the tank is
refilled again.
* Always monitor liquid level to prevent interrupted operation.
Caution: “Visibility during operation is reduced”.
WARNING
Use of any fluid other than ANTARI fog fluid or modification or attempt to unauthorized
repair of the X-Seies PRO Fogger will immediately invalidate the warranty.
!