Antari X-510 PRO - Manual (Page 12)

12
Maintenance & Storage
Do not allow the fog liquid to become contaminated. Always put the caps back on the fog liquid
container and the fog machine liquid tank immediately after filling. Do not operate the fog
machine without liquid at any time.
Clean with a dry cloth only. Store dry. Cleaning your fog machine regularly will help reduce costly
replacement and repair charges.
Note: All fog machines are prone to clogging due to the thick consistency of fog liquid and the
high temperature at which it vaporizes. It is strongly recommended to clean the fogger by running
with distilled water after every 2000 hours of operation. A properly maintained fog machine
should provide years of reliable use.
It is strongly recommended to test-run the machine on a monthly basis in order to achieve its best
fogging condition. A test-run consists of warming up the machine followed by a few minutes of
emission. Then please cool down the machine.
Specifications
MODEL X-510PRO X-515PRO
POWER AC100V/120V/230V, 50-60Hz
HEATER 1,000W 1,500W
OUTPUT 10,000 cu.ft/min 350m3/min 20,000 cu.ft/min 710m3/min
OUTPUT PRESSURE 68.6 kpa 49 kpa
HEAT UP TIME 11 min 8.5 min
FLUID CONSUMPTION
RATE
17 min/liter (100% output) 8.5 min./liter (100% output)
TANK CAPACITY 2.8 liter 6 liter
WEIGHT 11.5 kg 13.2 kg
DIMENSIONS(MM) L552 W230 H155 L646 W240 H190
Please read and save these instructions.