Antari X-510 PRO - Manual (Page 4)

4
* Never aim the output nozzle directly at people.
* Machine will warm up when operating, locate the fog machine in a well-ventilated area. Never
cover the unit's vents. In order to guarantee adequate ventilation, allow a free air space of at
least 30 cm around the sides and top of the unit.
* Never aim the output nozzle at open flames.
* The output nozzle becomes very hot during operation (200°C). Keep flammable materials at
least 50 cm away from the nozzle.
* Always allow your ANTARI X-PRO SERIES Fogger to cool down before attempting to clean or
service it.
Danger of Explosion
* Never add flammable liquids of any kind (oil, gas, perfume) to the fog liquid.
* Use only the high-quality, water-based ANTARI recommended FLG / FLR fog liquid. Other fog
liquids may cause clogging or damage to internal parts.
* Always make sure there is sufficient liquid in the fog liquid tank. Operating this unit without liquid
will cause overheating.
* If your ANTARI fog machine fails to work properly, discontinue use immediately. Drain all fog
liquid from the tank, pack the unit securely (preferably in the original packing material), and return
it to your ANTARI dealer for service.
* Always drain tank before mailing or transporting this unit.
* Never drink fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in contact with
skin or eyes, rinse thoroughly with water.
- Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the system has arrived
intact.
The shipping carton should include the following items:
1. One unit with power cable of the X-PRO SERIES series: X-510PRO or X-515PRO
2. X-10PRO Control Module with cables
3. Fluid tank
4. User manual
Important:
Pay attention to all warning labels and instructions printed on the exterior of
your ANTARI X-PRO SERIES Fogger.
!