Antari X-510 PRO - Manual (Page 10)

10
-Registering transmitters
To operate the machine with a different transmitter than the included one, or to operate it with up to 5
different transmitters, each transmitter must be registered first. For this purpose, turn on the machine.
When the display indicates 「Wireless Setup」, press the button “A” 1 second on each transmitter.
Thus the previous transmitters are cleared from the memory of the receiver. The setting must be
completed within 15 seconds after switching on the machine. Then the machine will automatically exit
the transmitter setting mode. The display shows 「Wireless Setup OK」. At this point, no further
transmitter can be added.
If no transmitter is registered when the machine is switched on, the memory of the receiver will keep
the record of the previous operation.
Setting Example 1:
In order to register several transmitters with a machine, turn on the machine. When the display
indicates 「Wireless Setup」, press the button “A” 1 second on each transmitter within 15 seconds to
establish the signal transmission.
Setting Example 2:
In order to use 1 transmitter to control 2 or more machines, turn on the machines respectively. When
the displays indicate「Wireless Setup」, press the button “A” 1 second on the transmitter within 15
seconds to establish the signal transmission.
- Battery change on the transmitter
If the range of the transmitter decreases, the battery is probably exhausted and must be replaced. For
this purpose, take off the housing cover and remove the used battery. Insert a fresh battery as
indicated in the battery compartment and refit the housing cover.
- Switching the wireless function on and off
Press the button FUNCTION until the display indicates 「Wireless On」. Use the buttons UP and
DOWN to deactivate the wireless function (indication 「Wireless Off」) and to reactivate it (indication
「Wireless On」).
* Note: When warming-up process is completed and wireless function is activated the LCD screen
indicates “Ready To Fog W”. (“W” means Wireless) On the contrary, when the wireless function is
deactivated the LCD screen shows “Ready To Fog” (Without “W”).