ALTANA Gardner-Scrub Short Instructions - Manual

269 020 584 E 0806
Additives & Instruments
A member of
Measure what you see.
BYK-Gardner GmbH · Lausitzer Strasse 8 · 82538 Geretsried · Germany · Tel. +49-8171-3493-0 · Fax +49-8171-3493-140 · www.byk.com/instruments
Please note the detailed operating instructions in English on CD.
ENGLISH
Gardner-scrub Abrasion Tester How to start the Gardner-scrub?
• Connect the power supply
• Turn on the power switch
• Setup the Instrument by using the touch screen
• Start procedure by pressing start button
How to prepare the test?
• Setup the instrument level by using the adjustable feet on the bottom
of the instrument.
• Affix the brush/sponge/pad holders to the carriage.
• Nuts on the holder should be fixed tightly secured to the bolts and the
bolts move freely through the holes in the carriage. Up to 3 standard
brush holders may be used at once.
• Insert prepared brushes/sponges/pads into holders
• Make sure all parts are in place including the metal tray, glass plate,
and test panel
• Press the clamps down firmly onto the sides of the lily frame to hold
everything in place. If no lily frame is used, clamp the test panel directly
at the sides close to the edge of the metal tray.
• To release clamps, apply sideways pressure.
Caution! Read Instruction Manual and all safety warnings before using this instrument.
The Gardner-scrub Abrasion Tester has moving parts which should never be touched during operation.
A Panel holder
B Sample tray
C Carriage
D Carriage release knob
E Brush/sponge holder
F Brush
G Bubble level
H Touch screen
I Adjustable feet
A
B
D
C
A
H
G
F
E
I