Acura 2000 NSX - Owner's Manual - Manual (Page 54)

Indicator Lights
Door and Lamp Monitor
(Except NSX-T) (NSX-T)
The appropriate light comes on in
this display if the rear window, trunk,
roof panel (on the NSX-T) or either
door is not closed tightly.
light comes on if either
headlight door fails to completely
open or close. If a brake light does
not work, the
BRAKE LAMP
indicator comes on when you push
the brake pedal with the ignition
switch ON (II).
A burned out brake light is a hazard
when drivers behind you cannot tell
you are braking. Have your brake
lights repaired right away.
All the lights in the monitor display
come on for a few seconds when you
turn the ignition switch ON (II).
Electric Power Steering
(EPS) Indicator
This light normally comes on when
you turn the ignition ON (II) and
goes off after the engine starts. If it
comes on at any other time, there is
a problem in the Electric Power
Steering system. If this happens,
stop the car in a safe place and turn
off the engine. Reset the system by
restarting the engine, and watch the
EPS light. If it does not go off, or
comes back on again while driving,
take the car to your dealer to have it
checked. With the light on, the EPS
is turned off, making the car harder
to steer.
Traction Control System
(TCS) Indicator
This indicator has three functions:
1. It comes on as a reminder that you
have turned off the Traction
Control System.
2. It flashes when the TCS is
regulating the engine power.
3. If it comes on and stays on when
the Traction Control System is on,
it indicates that there is a problem
in the TCS.
This light also comes on when you
turn the ignition ON (II) and goes off
after the engine starts. See page
274 for more information on the
TCS.
Instruments and Controls
EPS
TCS
Main Menu Table of Contents