Acura 2000 NSX - Owner's Manual - Manual (Page 223)

Lights
Replacing Rear Bulbs
The bulbs for the taillights, tail/stop-
lights, rear turn signals, and back-up
lights are behind the trunk liner.
1. Pull the top edge of the trunk liner
out from under the rubber seal.
Remove the plastic clips holding
the trunk liner by putting your
thumbs under the head of the clip
between the liner and body and
pushing the clip outward as you
wiggle it back and forth.
2. Determine which bulb in the
taillight assembly is burned out.
3. Remove the socket from the tail-
light assembly by turning it one-
quarter turn counterclockwise and
pulling it outward.
4. If the turn signal light bulb, back-
up bulb, or tail/stoplight bulb is
burned out, remove it by pushing
it in and turning counterclockwise.
If the taillight bulb is burned out,
remove it by pulling it straight out
of its socket.
5. Install the new bulb in the socket
in the reverse order of removal.
6. To reinstall the socket, line up the
tabs on the socket with the slots in
the taillight, push the socket into
the hole, and turn it clockwise
until it locks.
7. Test the lights to make sure the
new bulb is working.
8. Install the trunk liner clips by
pushing them straight in. Insert
the top edge of the liner back
under the rubber seal.
Maintenance
Main Menu Table of Contents