beautypg.com

Lights – Acura 2006 TSX - Owner's Manual User Manual

Page 293

background image

Open the hood. To change a bulb
on the driver’s side, undo the
three fasteners and remove the air
intake cover.

Remove the electrical connector
from the bulb by pulling the
connector straight back.

Remove the rubber weather seal
by pulling on the tab.

Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way, and remove the bulb
socket.

Pull the burned out bulb straight
out of its socket.
Push the new bulb straight into
the socket until it bottoms.

Insert the socket back into the
headlight assembly. Make sure
the bulb is installed correctly by
looking through the headlight lens.
Pivot the hold-down wire back in
place, and clip the end into the slot.

Install the rubber weather seal
over the back of the headlight
assembly. Make sure it is right
side up; it is marked with an arrow.

1.

2.

3.

6.

4.

5.

7.

Lights

292

FASTENER

AIR INTAKE COVER

HOLD-DOWN WIRE

BULB

CONNECTOR

RUBBER WEATHER SEAL

SOCKET

Table of Contents

Table of Contents