Acura 2006 TSX - Owner's Manual - Manual (Page 144)

To select a memorized position, do
this:
Make sure the parking brake is set
(M/T) or the shift lever is in Park
(A/T).
Readjusting the seat position.
Pressing the MEMO button again
within 5 seconds.
You cannot select a memorized
position if the transmission is in
reverse. Shift to another gear,
then select.
Doing any of the following after
pressing the MEMO button will
cancel the storing procedure.
All stored driving positions will be
lost if your vehicle’s battery goes
dead or is disconnected.
Not pressing a memory button
within 5 seconds.
Each memory button stores only one
driving position. Storing a new
position erases the previous setting
stored in that button’s memory. If
you want to add a new position while
retaining the current one, use the
other memory button.
Press the desired memory button
(1 or 2) until you hear a beep.
The system will move the driver’s
seat to the memorized position. The
indicator in the selected memory
button will flash during movement.
When the adjustment is complete,
you will hear two beeps, and the
indicator will stay on.
If the parking brake is not set, you
must press and hold the memory
button until the adjustment is
complete.
1.
2.
CONTINUED
Notes for vehicles with M/T
Selecting a Memorized Position
Driving Position Memory System
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
143
MEMORY BUTTONS
Table of Contents Table of Contents