Acura 2006 TSX - Owner's Manual - Manual (Page 198)

Dolby noise reduction
manufactured under license from
Dolby laboratories licensing
Corporation. ‘‘Dolby’’ and the
double-D symbol are trademarks
of the Dolby Laboratories
Licensing Corporation.
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Make sure the open side of the tape
is facing right, then insert the tape
most of the way into the slot. The
system will pull the tape in the rest
of the way, and begin to play it.
The tape direction indicator will light
to show you which side of the tape is
playing. The
indicates the side
you inserted upward is now playing.
If you want to play the other side,
press the Preset 3 (PLAY/PROG) or
press the AUDIO DISPLAY button
and touch either
or icon.
When the player reaches the end of
the tape, it will automatically reverse
direction and play the other side.
Dolby noise reduction turns on
when you insert a tape. The
indicator will light in the
display. If the tape was not recorded
in Dolby, turn it off by pressing the
Preset 4 (NR) or touching the NR
icon. Dolby remains off until you
press the preset button or the icon
again.
If you turn the system off while a
tape is playing, either with the PWR/
VOL knob or by turning off the
ignition, the cassette will remain in
the drive. When you turn the system
back on, the tape will begin playing
where it left off.
To switch to the radio or CD player
while a tape is playing, press the
AM/FM, or CD/AUX button or CD/
AUX XM button. To change back to
the tape player, push the CD/AUX
button or CD/AUX XM button.
CONTINUED
To Play a Tape To Stop Playing a Tape
Playing a Tape (Optional)
Fe
a
tu
re
s
197
Table of Contents Table of Contents