Maintain a constant vehicle speed without having to keep your foot on the
accelerator pedal. Use cruise control on freeways or open roads where you can
travel at a constant speed with little acceleration or deceleration.

Improper use of the cruise control can lead to a crash.
Use cruise control only when traveling on open highways in good weather.

Activating and Setting the Vehicle Speed

1. Press CRUISE. The CRUISE MAIN indicator appears.
2. Accelerate to the desired speed (above 25 mph/40

km/h). Press RES/+ and take your foot off the pedal
to set the speed. The CRUISE CONTROL indicator
appears.

Adjusting the Vehicle Speed

Press RES/+ to increase or SET/- to decrease.
Each time you press the button, the vehicle speed is
increased or decreased by about 1 mph (1 km/h). If you
keep the button pressed, the vehicle speed increases or
decreases until you release it.

Canceling Cruise Control

Press CANCEL or the brake pedal. The CRUISE
CONTROL indicator goes off.
After cruise control has been canceled, you can still
resume the prior set speed by pressing RES/+ while
driving at a speed of at least 25 mph (40 km/h).
Press CRUISE to turn the system off.

CRUISE button

RES/+ button

SET/- button

CANCEL button

WARNING

Adaptive Cruise Control (ACC) with Low Speed Follow*

Helps maintain a constant vehicle speed and a set following distance behind a
vehicle detected ahead of yours. When the vehicle ahead changes speed, ACC
senses the change and accelerates or decelerates to maintain a set interval.

MAIN button
RES/+ button
SET/- button
CANCEL button
Distance button

Activating and Setting the Vehicle Speed

1. Press MAIN. The ACC indicator appears.
2. Accelerate to the desired speed.

Above 25 mph/40 km/h: Press SET/- and take
your foot off the pedal to set the speed.
Below 25 mph/40 km/h (Low Speed Follow):
Press SET/- to set the speed below 25 mph/40
km/h when there is a vehicle ahead of you. If
there is no vehicle ahead, ACC will not engage.

Adjusting the Vehicle Speed

Press RES/+ to increase or SET/- to decrease.
Each time you press the switch up or down, the
vehicle speed is increased or decreased by about
1 mph (1 km/h). If you keep the switch pressed up or
down, the vehicle speed increases or decreases by
5 mph (8 km/h) until you release it.

Adjusting the Following Distance

Press the Distance button to change the following
distance. Each time you press the button, the following
distance cycles through short, middle, long, and extra
long.

Switching to Standard Cruise Control

Press and hold the Distance button.

*if equipped