Preparation, Installing / exchanging batteries, Setting up the scale – A&D Weighing SJ-30KWP User Manual
Page 6
4
3. PREPARATION
3.1. Installing / Exchanging batteries
The batteries are not included with the product. Prepare 6 x “D” size (R20P or LR20)
dry-cell batteries.
When the
mark is displayed,
exchange the old batteries with new ones.
1. Loosen the screws for securing the
battery cover using the provided
screwdriver, and remove the battery
cover.
2. Remove all the old batteries from the
battery compartment.
3. Install six new batteries properly
according to the + and - indicators of
polarity in the battery compartment.
4. Close the battery cover, and tighten the
screws for securing the battery cover.
CAUTION - Do not mix used and new batteries. Do not mix the different types
of batteries. That may cause damage to the batteries or the scale.
- Take care of the polarity of batteries. The polarity marks are shown
in the battery compartment.
3.2. Setting up the scale
CAUTION Avoid installing the scale in direct sunlight, that may cause
discoloration or malfunctions. Place your SJ-WP on a firm weighing
table so that the scale is level. The scale will not perform accurately
when it is not level.
Place the scale on a firm surface and adjust the feet so that the bubble of the
sprit level is in the center of the circle.
(R20P/ LR20
/ D size)
Six new
batteries
Battery
cover
Screw for
securing
Old
batteries
OK NG