Panasonic EY3530NQMKW - Manual (Page 6)

can cause KICKBACK, or a live wire couM
cause electric shock.
19) The risk ol kickback Increases as the
battery peek (Hscharges.
20) Be sure to inspect mMarlak Avoid cutting
bolts, naUs or other different maleilaL
21) Be caiefuf not to drop Metal Cutter.
22) Never swing Metal Cutler.
23) Wsvsr cover toe vsnIHation slots, and keep
tosfn free ftom dust or ctosr пм1вг1а1.
24) Do not damp Metal Cutlsr In a vlat. Never
cut wHh UotsI Cutter held upside down in
a vise. Thie It cxbremely dsngeroue and
can lead to ssftous scddents.
25) Nevsr wear kntttad glovaa.
26) Ba aura no ona It balow whan using
Metal Cutter in high locationa.
27)
Do not touch tha blade Immadiataty
after oparatloa It may be hot and could
bum your akin.
Symbol Meaning
V volts
_______ Direct Current
rV) no load speed
— / min
revolutions or reciprocation
per minute
FOR BATTERY CHARGER &
BATTERY PACK
SAVE THESE IN­
STRUCTIONS
T».
manual contains important safety and
operating instructions for battery charger
EY0230.
1) Before using battery charger, read all
instructions and cautionary markings on
(1) battery charger, (2) battery pack.
2)
CAUTION
-To reduce the risk of
injury, charge only Battery Pack EY9001,
EY9O0O, EYdOSS, EY90Q6, EY9086, EY9101,
EY9180, EY9182, EY9106, EY9107. EY»136,
EY9230, EY9200, EY9108.
Other types d batteries may burst caus­
ing personal injury and damage.
3} Do rwt expose charger to rain or snow.
4) To reduce risk of damaging the electric
phjg arxl cord, puMby plug rather than cord
when disconnecting charger.
5) Make sure cord is located so that it wll not
be stepped on, tripped over, or otherwise
subjected to damage or stress.
6) An extension cord should not be used
unless absolutely necessary.
Use of improper extension cord could
result in a risk of fire and electric shock. If
extension cord must be used, make sure;
a. toat pins on plug of extension cord are
the same nurdwr, size and shape as
those of plug on charger.
b. that extension cord is property wired
and in good electrical oondiUon.
c. that wire size is laiye enough tor ampere
rating of charger as specified below.
RECOMMENDED MINIMUM AWQ SIZE OF
EXTENSION CORDS FOR
BATTERY CHARGERS
AC Input Rating. Ampens AWG Size Of Cord
Equal to or But less
graatarihan than
Length of Cord, Feet
25 SO 100 150
0 2 15 18 18 16
7) Do not operate charger with damaged cord
or plug-^ake itto a qualified serwoeman.
8) Do not operate charger if It has received
a sharp blow, been dropped, or otherwise
damaged in any way; take it to a qualifted
serviceman.
9) Do not disassemble charger; take it to a
qualified serviceman when service or
repair is required, incorrect reassembly
may result in a risk of electric shock or
fire.
10) To reduce the risk of electric shock, unplug
charger from outlet before attempting any
maintenence or cleaning.
11) The charger and battery pack are ^wciHcally
designed to work togetoer. Do not attempt to
charge any other cordless tool or battery
pack with this charger.
12) Do not attempt to charge the battery pack
with any other charger.
13) Do not attempt to disaseemble toe battery
pack housing.
14) Do not store the tool and battery pack In
locations where the tsmperatuie may teach
or exceed 122**F (50**C) (such a mstal tad
shad, or a car in the summer), which can
lead to deterioration of toe battery pack.
15) Do not charge battery pack when the
temperature is BELOW 32**F (0*C) or
ABOVE 104*F (40“C).