Panasonic EY3530NQMKW - Manual (Page 15)

WARNING
Because cutting metal creates sparks;
• Always use safety goggles.
• Do not use metal cutter near any flammab^ substance or in an area where flammable
substances are used. Rre and bum ir^ury could result.
8. Never engage the shaft lock while blade is running, or engage in an effort to stop the tool.
Never turn the switch on when the shaft lock is engaged. Serious damage to your metal cutter
will result.
Maintenance
WARNING
To avoid severe personal injury, always
lemoee the battery pack from the metal cutter
before starting any maintenanoe procedure.
CAUTION
To asaura ptodud SAFETY and SEUABIUTY,
servicing shoiM be perforrned by an authorized
service center. Always insist on genuine
Panasonic replacement parts.
Removing Blade
CAUTION
The blade will be hot right after cutting. Be
sure to let the blade cool down before
lemowngK.
Lower guard Hit lever
Tighten
Follow these steps:
1. Remove the battery pack from the metal
cutter.
2. Hold the shaft lock button dowa This prevents
the blade from noticing.
3. Use the provided hex wrench to loosen the
hex bolt.
NOTE
Keep the hex wrench in the storage slot on
the metal cutter's body when not using ft,
4. Remove the hex bolt and outer washer.
5. Use the lower guard lift lever to retract
(open) the lower guard.
6. Carefully remove №e blade.
7. Clean the metal cutter if necessary.
CAUTION
• Be careful to avoid cutting your hands on
the blade.
When disposing of a blade, secure it inside
heavy or corrugated paper. 'Riis will help
prevent anyone from being cut by the
discarded blade.
Inrwr washer
Shaft locktxitton
Plaça Iha Inrwr waihar
with cut-out facing you.
Place the prolrutkxi of
Iha outar waahar Into Iha
poattion of ttw wBShar.
Rg.13
— ia —