Before using metal cutter, Warning, Operation – Panasonic EY3530NQMKW User Manual

Page 10: C l ), Inserting battery pack, Caution, Lamp indication

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Lamp indication

—

FltiNnflquicWy

- C l ) ,

►CD

Chaîner ts ptuggM Into a waH outlet Reedy
toctwoe.

Now charging

Charging le completed

Protective charging

Battery peck le warm. Charging wilt begin

when temperature of battery pack dtope.
Charging la not poeelble. Clogged with
dust or maHunction of the battery pack.

Inserting Battery Pack

Operation

CAUTION

Before Inserting the battery pack, check

that the power switch In the Metai Cutter
actuates properly and returns to the ‘OFP
position when released.

1. To insert the battery pack:

Slide the battery pack in place at the rear of

the metal cutter. The battery should snap

into place. If the battery Is loose, It has not
been property connected.

Press the two tabs on the sides of the battery
pack. Sbde the battery pack out of the metal

cutter body.

Before Using Metal Cutter

Each time you use the metal cutter, you must

make sura it is in good operating condition.
Use the following checklist:

1. Is №e blade installed in the correct direction?

The arrow on the blade must point In the
same direction as the arrow on the upper
blade cover.

2. Is the blade installed properly?

Make sure the hex bolt is tightened

securely. (See Fig. 13 page 16}

3. Does the blade look all right?

Retrace the blade immediately if there are

any cracks in it or if any teeth are broken.

4. Does the lower blade guard close property?

WARNING

To avoid Injury, do not use the metal cutter

if the lower blade guard does not close

quickly over the blade.

5. Is the transparent window securely

installed?

6. is the battery pack charged arnf inserted

firmly to the metal cutter?

—